Description

Great value full size automotive paint spray booth kit with electric heating and optional water based paint drying venturi system

Downdraught extraction is a very efficient way of spraying as it draws the air around the vehicle and brings the panels up to temperature quickly. Very environmentally efficient booth with no gas or diesel emissions.

External dimensions 700cm long, 400 wide (excluding fan cabinet) 530cm wide (including fan cabinet), 325cm high

Internal dimensions 690cm long, 390cm wide, 260cm high (also available as a ‘high top’ and with extra length)

Blower system Downdraught, with raised floor system (no pit required)

Heating type Halogen shortwave infrared

Heating system 10 x heater panels, each one with 3 x 1kW elements, total heating power 30kW.

Heating panels 2 x rear mounted panels, 4 x each side

Heating time From 20 degrees to bake temperature takes around 5-10 minutes

Intake fan 2 x 3kW double intake centrifugal fan, 20000m3/h capacity (4.7 air changes/minute) – blower cabinet and control panel can be mounted left or right side – approximately 3.5 air changes per minute for the standard height booth

Exhaust fan 1 x 4kW fan, 12500m3/h capacity

Fan cabinet Powder coated steel, galvanized exhaust – Left, right or rear side blower cabinet options.

Optional water based paint system 2 x 550W double inlet centrifugal fans with 20 x nozzles. Consists of 2 x corner mounted cabinets each with 10 adjustable nozzles

Main door 3-way folding door, 300cm wide, 250cm high

Side door Side pedestrian door 70cm wide, 180cm tall

Roof 40*40mm galvanised

Walls 50mm steel composite board with EPS insulation

Floor 1.2mm galvanised with 30*4mm steel grid for extraction

Ramps 1 x pair of 1.8m x 65cm entry ramps included – optional internal ramp

Lighting 8 x sets of roof lights each with 4 tubes (LED), 8 x sets of wall lights each with 4 tubes (LED)

Filter system Intake filter for particles larger than 10µm, roof filter with 2 x rows fibreglass filter for particles larger than 4µm, fibreglass floor filter TSP≤14mg/m³

Electrical system Controls for lighting, spray/bake, temperature control, emergency stop, three-way control

Electrical requirements 3 phase, 40.5kW (max) – 30kw for the heater panels (can be reduced by fitting fewer), 10kW for blower fans, 0.5kW for lights & water based blowers.

Exhaust duct 5 x straight 900mm, 2 x 90 degree bend, 700x700x900mm, 0.6mm galvanised – extra ducting available if required

Delivery time Normally 45-60 days – contact to check stock as we sometimes have stock ready for delivery immediately

Demonstration booth – Demo booth installed near Salisbury (high-top, with water based), contact us to book a visit

Optional Extras

‘High top’ booth suitable for minibuses, high vans, etc. includes 300cm high door/310cm high internal roof + £600

Water based paint system blowers + £800 – 2 x 550W double inlet centrifugal fans with 20 x nozzles.

Left, right or rear side blower cabinet options.

Terms Supplied in kit form only, delivered to mainland UK using our own transport. Kerbside delivery only, will need a forklift and some helpers. Full video installation instructions available, plus diagrams and schematics. Assembly must be on a clean, flat and level base and will take 2 people around 3-5 days. Prices quoted are PLUS VAT.